USPS labels can be printed with a laser printer, a good-quality inkjet printer or a compatible 4×6 label printer; the required result is a complete, correctly scaled and readable label.

Which printer should you choose?

Printer Good fit Check carefully
4×6 thermal label printer Frequent package labels and peel-and-stick workflow Driver, PDF size, label stock and platform compatibility
Laser printer Plain paper or sheet labels with crisp output Correct media setting, scale and secure attachment
Inkjet printer Occasional labels with suitable ink and paper USPS recommends high-quality output; avoid smearing or low contrast
No printer Supported Label Broker transaction A supported paid transaction with a USPS Label Broker ID or QR code, a participating counter or kiosk, and an unexpired ship date; an arbitrary retailer QR code is not enough.

USPS label size and scaling

Approximately 4×6-inch output is common for package labels, while ordinary paper can also be used in supported workflows. Print at the size generated by the postage system. Do not use “fit to page” when it distorts, crops or shrinks the barcode and address block.

Print-before-mail checklist and troubleshooting

Preview the paid label at its intended size, print at 100% when the generated format calls for it, and check all four edges, address, postage evidence and barcode. Attach it flat on a suitable package face; keep seams, wrinkles and glossy tape away from the bars. Use this diagnostic if the first test fails:

What you see on the test label Likely setting to check Next test
Address or barcode is cut off at an edge Wrong 4×6 media size, printable margin or driver orientation Preview all four edges, select the correct stock and reprint the full original label.
The whole label is tiny or stretched “Fit to page,” scaling or an A4/letter versus 4×6 mismatch Use the generated PDF’s intended size and 100% scaling; confirm the address and barcode remain complete.
Bars look gray, streaked or broken Low ink or toner, dirty thermal head, incompatible stock or draft quality Clean or replace the supply, use suitable media and reprint until the barcode is dark and sharp.

These checks are a diagnostic aid, not permission to redraw or alter the paid barcode. If the original label data is wrong, correct the shipment in the postage system and issue a new label under its rules.

Problems a new printer will not fix

A printer cannot correct an invalid label, wrong weight, bad address, expired transaction or unsupported service. Resolve data and payment errors in the postage system rather than editing the output. For the full range of postage methods, see prepaid postage options.

One paid label, two supported printing routes

After paying in Click-N-Ship, print its PDF or, if offered for that transaction, select “Print at Post Office” and bring the emailed USPS Label Broker QR code or ID and ready-to-ship package to a participating counter or kiosk. The USPS Click-N-Ship help says a label must be used on or before its ship date; check the transaction’s print/reprint window as well. A merchant QR code works only if that merchant created a supported Label Broker transaction, not merely because it is a QR code.

Sources and update note

Facts and availability checked September 10, 2026.