Direct answer

Do not put tape across the face of a stamp: DMM 604.1.3 invalidates U.S. stamps covered or coated so cancellation marks cannot be printed. Tape elsewhere on an envelope is a different matter. The three case-specific remedies below distinguish failed adhesive, a torn stamp and an already-covered stamp.

Affix the stamp firmly and leave its printed face visible and cancellable.

Why tape should not cover a stamp

USPS mailing standards require postage to be affixed so it can be recognized and canceled. A transparent coating can change the surface, obscure part of the design, or prevent a normal cancellation mark. The problem is the tape covering the postage—not the mere presence of tape somewhere else on an envelope.

Overlapping stamps create a similar issue: a covered portion cannot reliably be counted as visible postage. Lay multiple stamps flat without overlap when combining values.

What to do if an unused stamp will not stick

  1. Avoid tape or coating across the stamp face; an edge-only repair is not automatically approved by a USPS millimeter rule.
  2. Keep the backing, packaging, and purchase record if available.
  3. Use a different intact, unused stamp when the letter must be mailed promptly.
  4. Ask the seller or a USPS retail counter about the defective stamp rather than guessing whether it will be accepted.

Do not remove a stamp from previously processed mail and reattach it. Used postage cannot be reused. The guide to stamp validity and expiration explains the difference between old unused postage and already-used postage.

Damaged, torn, or partly taped stamps

USPS must judge the condition of a specific piece. DMM 604.1.3 rejects mutilated, defaced or impermissibly covered postage, while USPS Customer Support Ruling PS-281 addresses the specific question of torn stamps. A tiny edge defect and a heavily torn stamp are not the same situation, but the safe response is to replace uncertain postage or present the piece at a retail counter; do not assume a general exchange or refund entitlement.

Three visual cases to check before mailing

Stamp condition What to do When counter inspection matters
Unused stamp, failed adhesive: complete clean face and edges, but it will not stay attached; no cancellation or evidence of prior use. Do not tape over its face. Use another intact unused stamp for urgent mail; keep the defective stamp and proof of purchase for the seller or USPS. Ask the retail counter whether the particular defective stamp can be exchanged or otherwise handled before attempting to mail with it.
Transparent tape across the face: design or cancellation area has a glossy tape layer, even if the printing is still visible. Do not assume a machine can recognize or cancel it. Do not stack another stamp over it or peel it off in a way that damages the mailpiece. Bring the whole envelope to a Post Office before deposit; if its status cannot be confirmed, use fresh uncovered postage.
Severe tear or missing piece: design, denomination or a substantial portion of the stamp is gone. Do not join fragments with tape or use the remnant as postage. Replace the postage for mailing. Ask about possible exchange of an unused remnant; the USPS torn-stamp ruling distinguishes a minor corner tear from a substantial missing portion, and the actual remnant must be assessed.

Place the stamp correctly

Affix the stamp flat in the upper-right corner of the address side. Keep it clear of the return address, delivery address, envelope edge, clasps, and other stamps. See the illustrated stamp-placement guide when using several stamps or a nonstandard envelope.

USPS sources and review note

DMM 604 and PS-281 were rechecked September 28, 2026. Acceptance of a particular damaged or covered stamp requires inspection of the actual mailpiece.

Explore the complete topic

This page covers one focused task. Return to how to mail an envelope usps to compare the related pages, products, tools and reference material in this topic.